2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Accessory AC and DC Power Control Module Replacement

Fig 1: Accessory AC and DC Power Control Module
GM4284283Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove Front Floor Console. Refer to Front Floor Console Replacement (Base)Front Floor Console Replacement (Up Level)
1 Accessory AC and DC Power Control Module

Procedure

  1. Disconnect the electrical connector.
  2. Unlock the retaining tabs.
  3. When the replacement is completed, use a scan tool to perform the appropriate reset functions. Refer to Control Module References
Chapter Navigation
Return to Chapter: Repair Instructions
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.