2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: Instrument Panel Fuse Block Access Hole Cover
    GM3642910Courtesy of GENERAL MOTORS COMPANY
  1. Remove Instrument Panel Fuse Block Access Hole Cover (1)
  2. Fig 2: Front Floor Console Extension Panel
    GM4377267Courtesy of GENERAL MOTORS COMPANY
  3. Remove the bolt (1).
  4. Release the 5 retaining tabs (2).
  5. Remove the left and right front floor console extension panel (3).
  6. Fig 3: Instrument Panel Fuse Block Access Cover Frame
    GM3682514Courtesy of GENERAL MOTORS COMPANY
  7. Remove the left and right instrument panel fuse block access cover frame (1).
  8. Fig 4: Instrument Panel Lower Trim Panel Insulator
    GM4290319Courtesy of GENERAL MOTORS COMPANY
  9. Remove the bolt (1).
  10. Remove the 4 retaining clips (2).
  11. Remove the instrument panel lower trim panel insulator (3).
  12. Fig 5: Instrument Panel Lower Airbag And Nuts
    GM4290300Courtesy of GENERAL MOTORS COMPANY
  13. Remove Instrument Panel Lower Airbag Nuts (1)
  14. Remove Instrument Panel Lower Airbag - Passenger Side (2)
  15. Disconnect the electrical connector.
  16. Fig 6: Instrument Panel Outer Trim Cover - Right Side
    GM3686273Courtesy of GENERAL MOTORS COMPANY
  17. Remove Instrument Panel Outer Trim Cover - Right (2)
  18. Unlock the retaining tabs (1).
  19. Fig 7: Instrument Panel Compartment And Bolts
    GM4422282Courtesy of GENERAL MOTORS COMPANY
  20. Remove Instrument Panel Compartment Bolts (1) (Qty: 5)
  21. Remove Instrument Panel Compartment (2)
  22. Disconnect the electrical connector.
  23. Fig 8: Human Machine Interface Control Module Bracket And Bolt
    GM4421922Courtesy of GENERAL MOTORS COMPANY
  24. Remove Human Machine Interface Control Module Bracket Bolt (1) @ Human Machine Interface Control Module Bracket (2)
  25. Disconnect the electrical connector.
  26. Fig 9: Human Machine Interface Control Module Bracket And Bolt
    GM4421923Courtesy of GENERAL MOTORS COMPANY
  27. Remove Human Machine Interface Control Module Bracket Bolt (1) @ Human Machine Interface Control Module Bracket (2)
  28. Fig 10: Human Machine Interface Control Module Bracket
    GM4421924Courtesy of GENERAL MOTORS COMPANY
  29. Remove Human Machine Interface Control Module Bracket (1)
  30. Transfer components as necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.