Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Remove Instrument Panel Fuse Block Access Hole Cover (1)
- Remove the bolt (1).
- Release the 5 retaining tabs (2).
- Remove the left and right front floor console extension panel (3).
- Remove the left and right instrument panel fuse block access cover frame (1).
- Remove the bolt (1).
- Remove the 4 retaining clips (2).
- Remove the instrument panel lower trim panel insulator (3).
- Remove Instrument Panel Lower Airbag Nuts (1)
- Remove Instrument Panel Lower Airbag - Passenger Side (2)
- Disconnect the electrical connector.
- Remove Instrument Panel Outer Trim Cover - Right (2)
- Unlock the retaining tabs (1).
- Remove Instrument Panel Compartment Bolts (1) (Qty: 5)
- Remove Instrument Panel Compartment (2)
- Disconnect the electrical connector.
- Remove Human Machine Interface Control Module Bracket Bolt (1) @ Human Machine Interface Control Module Bracket (2)
- Disconnect the electrical connector.
- Remove Human Machine Interface Control Module Bracket Bolt (1) @ Human Machine Interface Control Module Bracket (2)
- Remove Human Machine Interface Control Module Bracket (1)
- Transfer components as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
