2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Side Object Sensor Replacement

Fig 1: Side Object Sensor
GM4284231Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove Rear Bumper Fascia. Refer to Rear Bumper Fascia Replacement (Notchback)Rear Bumper Fascia Replacement (Hatchback)
1 Side Object Sensor

Procedure

  1. Disconnect the electrical connector.
  2. Release the locking retainer from the side object sensor bracket.
  3. Perform the scan tool learn/reset function: Control Module References .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.