2017 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Parking Assist Control Module Replacement (Notchback)

Fig 1: Parking Assist Control Module (Notchback)
GM4060561Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect Battery Negative Cable. Refer to Battery Negative Cable Disconnection and Connection
  2. Remove Rear Compartment Side Trim - Left Side. Refer to Rear Compartment Side Trim Replacement - Left Side (Notchback)
1 Parking Assist Control Module Nut (Qty: 2)
CAUTION:

Refer to Fastener Caution


Tighten 
5.5 N.m (49 lb in)
2 Parking Assist Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Perform the scan tool learn/reset function: Control Module References
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.