Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Chevrolet Suburban 3500 HD LSFACTORY OEM SERVICE PROCEDURE
Replace and Program Control Module or Reprogram Control Module
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 GMC Yukon XL, 2015 GMC Yukon, 2015 Chevrolet Tahoe, 2015 Chevrolet Suburban, and 2015 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing control module, perform the following procedure:
- Install EL-49642Β SPS Programming Support Tool.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Suspension Control Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Suspension Control Module - Setup and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
- With a scan tool, perform the Suspension Sensor Trim Height Calibration, if applicable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
