2016 Chevrolet Suburban 3500 HD LSFACTORY OEM SERVICE PROCEDURE

Setup for Component Replacement - Fuel Pump Driver Control Module Configuration / Fuel Pump Power Control Module Configuration

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 GMC Yukon XL, 2015 GMC Yukon, 2015 Chevrolet Tahoe, 2015 Chevrolet Suburban, and 2015 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode - For 2 min
  2. Ignition/Vehicle - Off - For 2 min
  3. Ignition » On / Vehicle - In Service Mode
  4. Perform the following action: Cylinder Deactivation Exhaust Control Valve Learn (If applicable)
  5. Perform the following action: Clear the DTCs.
  6. Start Engine
  7. Verify DTC1005 is not set

    If the DTC sets 

    1. Perform the following action: Clear the DTCs.
    2. Ignition/Vehicle - Off - For 2 min
    3. Start Engine
    4. Verify the DTC does not set.
      • If the DTC sets - Repeat the procedure starting at step 1
      • If the DTC is not set - Configuration - Complete

    If the DTC is not set 

  8. Configuration - Complete
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.