2016 Chevrolet Suburban 3500 HD LSFACTORY OEM SERVICE PROCEDURE

Unsuccessful Programming Recovery

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 GMC Yukon XL, 2015 GMC Yukon, 2015 Chevrolet Tahoe, 2015 Chevrolet Suburban, and 2015 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.

In the event of an interrupted or unsuccessful programming event, perform the following steps:

  1. Ignition ON. Ensure the control module, DLC, and programming tool connections are secure and the SPS software is up to date.
  2. Verify the control module can be reprogrammed.
    • If the control module cannot be reprogrammed 
    1. Ignition OFF for one minute, ignition ON.
    2. Verify the control module can be reprogrammed.
      • If the control module cannot be reprogrammed, replace the control module.
      • If the control module can be reprogrammed.
    3. All OK.
    • If the control module can be reprogrammed 
  3. All OK.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.