2016 Chevrolet Spark LS, Standard TransFACTORY OEM SERVICE PROCEDURE

Rear Object Alarm Replacement

WARNING: This page is about a different car, the 2015 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Object Alarm
GM2327693Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the rear wheelhouse trim finish. Refer to Rear Wheelhouse Trim Finish Panel Replacement .
1 Rear Object Alarm Nut
CAUTION: Refer to Fastener Caution .

Tighten 
4.5 N.m (40 lb in)
2 Rear Object Alarm

Procedure

  1. Disconnect the electrical connector.
  2. Remove the rear object alarm.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.