Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Chevrolet Spark LS, Standard TransFACTORY OEM SERVICE PROCEDURE

Multifunction Relay Module Bracket Replacement (Without Front View Camera)

Fig 1: Multifunction Relay Module Bracket (Without Front View Camera)

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Preliminary Procedure

Remove Inside Air Moisture and Windshield Temperature Sensor (if equipped). Refer to Inside Air Moisture and Windshield Temperature Sensor Replacement
Remove Inside Rearview Mirror. Refer to Inside Rearview Mirror Replacement

Multifunction Relay Module Bracket

Procedure

Unclip wiring as necessary.
Slide the bracket upward to disengage tabs, gently pull from windshield.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.