2016 Chevrolet Spark EVFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Electric Power Steering Module And Bracket Bolts
    GM2778814Courtesy of GENERAL MOTORS COMPANY
  1. Position the electronic power steering control module (2) on the electronic power steering control module bracket (3).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the electronic power steering motor control module to bracket bolts (1) and tighten to 3 N.m (27 lb in).
    3. Fig 2: Electric Power Steering Module Bracket Bolts
    GM2778809Courtesy of GENERAL MOTORS COMPANY
  3. Position the electronic power steering motor control module and bracket in the vehicle.
  4. Install the electronic power steering motor control module bracket bolts (1) and tighten to 18 N.m (13 lb ft).
  5. Connect any electrical connectors as necessary.
  6. Install Instrument Panel Lower Airbag - Driver Side Instrument Panel Lower Airbag Replacement - Driver Side
  7. Install Instrument Panel Knee Bolster Instrument Panel Knee Bolster Replacement
  8. Install Steering Column Lower Trim Cover Steering Column Lower Trim Cover Replacement
  9. If a NEW electronic power steering motor control module is installed, program the module. Control Module References
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.