2016 Chevrolet Spark EVFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Engine Control Module (ECM)
    GM3240558Courtesy of GENERAL MOTORS COMPANY
  1. Install the ECM module (2) into the retaining bracket.
  2. Fig 2: Engine Control Module (ECM) Connectors And ECM Module
    GM3232226Courtesy of GENERAL MOTORS COMPANY
  3. Install the ECM connectors (1) to the ECM module (2).
  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.