2016 Chevrolet Spark EVFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: ECM Module, ECM Module Bracket And Retaining Tab
    GM3232224Courtesy of GENERAL MOTORS COMPANY
  1. Install the ECM module (2) into the ECM module bracket.
  2. Fig 2: Engine Control Module Bracket Retainers And Battery Tray
    GM3216629Courtesy of GENERAL MOTORS COMPANY
  3. Attach the ECM module bracket retainers (3) to the battery tray (2).
  4. Fig 3: ECM Module Bracket, Fastener And Retaining Tab
    GM3232225Courtesy of GENERAL MOTORS COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.