Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Chevrolet SS Automatic TransFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Disconnect the battery ground cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
- Remove the engine cover. Refer to Engine Cover Replacement .
- Disconnect the fuel injection fuel feed hose. Refer to Fuel Injection Fuel Feed Hose Replacement .
- Reposition the engine wire harness as necessary.
- Disconnect the spark plug wires (1) from the ignition coils.
- Disconnect the main ignition coil harness connector (1) from the ignition coil assembly.
- Remove the ignition coil assembly to rocker cover retaining bolts (2).
- Remove the ignition coil assembly from the engine.
- Disconnect the ignition coil to ignition coil wiring harness connectors (1).
- Remove the ignition coil to ignition coil assembly retaining bolts (1).
- Remove the ignition coils from the ignition coil assembly.
WARNING:
Refer to Battery Disconnect Warning .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.