2016 Chevrolet SS Automatic TransFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Remove the engine cover. Refer to Engine Cover Replacement .
  2. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief .
  3. Clean the fuel rail assembly before disconnection the fuel connections.
    4. CAUTION:
    • Remove the fuel rail assembly carefully in order to prevent damage to the injector electrical connector terminals and the injector spray tips. Support the fuel rail after the fuel rail is removed in order to avoid damaging the fuel rail components.
    • Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering open pipes and passages.
  4. Disconnect the fuel feed hose from the fuel rail. Refer to Fuel Injection Fuel Feed Hose Replacement .
    5. Fig 1: Injector Electrical Connectors
    GM1950743Courtesy of GENERAL MOTORS COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.