2016 Chevrolet SS Automatic TransFACTORY OEM SERVICE PROCEDURE

Communication Interface Module Bracket Replacement

Fig 1: Communication Interface Module Bracket
GM3581497Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the instrument panel lower airbag - driver side. Refer to Instrument Panel Lower Airbag Replacement - Driver Side
  2. Remove the instrument panel lower trim panel insulator panel. Refer to Instrument Panel Lower Trim Panel Insulator Replacement - Left Side .
  3. Remove the communication interface module to access the bracket fastener. Refer to Communication Interface Module Replacement .
  4. Remove the communication interface module battery to access the bracket fastener. Refer to Communication Interface Module Battery Replacement .
1 Communication Interface Module Bracket Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Communication Interface Module Bracket Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
3 Communication Interface Module Bracket
Chapter Navigation
Return to Chapter: Repair Instructions
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.