2016 Chevrolet SS Automatic TransFACTORY OEM SERVICE PROCEDURE

Side Object Sensor Replacement

Fig 1: Side Object Sensor
GM2910568Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedures 
Remove the front bumper fascia. Refer to. Front Bumper Fascia Replacement
1 Side Object Sensor Front

Procedure

  1. Disconnect the side object sensor electrical connector.
  2. Release the locking tabs on the side object sensor.
  3. The side object sensor is a one piece design. Do NOT twist the sensor cap to try to remove the painted cap.
  4. Remove and replace the side object sensor. Replacement sensor is purchased pre-painted to match fascia/bumper body color.
NOTE:
  • Do NOT refinish previously painted sensors. Excess paint build up can cause the sensor to be rendered inoperative.
  • Ensure the silicone decoupling ring is installed on the sensor to avoid sensor failure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.