2016 Chevrolet Malibu LSFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Fuel Tank Fuel Pump Module
    GM4230590Courtesy of GENERAL MOTORS COMPANY
  1. Install New O-Ring (2)
  2. Install Fuel Tank Fuel Pump Module (1)
  3. Fig 2: Fuel Pump Vent Pipe
    GM4240201Courtesy of GENERAL MOTORS COMPANY
  4. Connect Fuel Pump Vent Pipe (1) - Plastic Collar Quick Connect Fitting Service 
  5. Fig 3: Fuel Pump Lock Ring
    GM4230523Courtesy of GENERAL MOTORS COMPANY
  6. Install Fuel Pump Lock Ring (1) - CH 45722  Fuel Sender Lock Ring Wrench
  7. Fig 4: Electrical Connector
    GM4230507Courtesy of GENERAL MOTORS COMPANY
  8. Connect Fuel and EVAP Pipe (2) (Qty: 2) - Plastic Collar Quick Connect Fitting Service 
  9. Connect Electrical Connector (1) at Fuel Tank Fuel Pump Module (Qty: 2)
  10. Install Fuel Tank Replacement 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.