Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Chevrolet Malibu LSFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- If replacing the engine control module, reprogram the module. Control Module References
- Install Engine Control Module (3)
- Install Engine Control Module Cover (2)
- Engage Engine Control Module Bracket Retaining Tabs (1) (Qty: 2)
- Install Engine Control Module And Bracket Assembly (2)
- Install Engine Control Module Bracket Bolt (1) to 9 N.m (80 lb in)
- Connect Electrical Connector at Engine Control Module.
- Connect Battery Negative Cable Disconnection and Connection (with KL9)Battery Negative Cable Disconnection and Connection (without KL9) .
CAUTION:
Refer to Fastener Caution .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
