2016 Chevrolet Cruze LT, Standard TransFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Engine Control Module Bracket (1)» Install
    Fig 1: Engine Wiring Harnesses
    GM3680272Courtesy of GENERAL MOTORS COMPANY
  2. Engine Wiring Harness (2) @ Engine Control Module Bracket (1)» Install - Retainer (3)» Tighten [2x]
  3. Engine Control Module Replacement » Install
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.