2016 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

Application Specification
Metric English
Steering Gear Heat Shield Bolt 9 N.m 80 lb in
Steering Linkage Inner Tie Rod 85 N.m 63 lb ft
Steering Linkage Inner Tie Rod Nut 60 N.m 44 lb ft
Steering Linkage Outer Tie Rod Nut (1)
  • First Pass:
 35 N.m 26 lb ft
  • Final Pass:
 30 - 45 Degrees
Electric Belt Drive Rack and Pinion Steering Gear Bolt and Nut (1)
  • First Pass:
 55 N.m 41 lb ft
  • Final Pass:
 150 - 165 Degrees
Front Stabilizer Shaft Bolt (1)
  • First Pass:
 22 N.m 16 lb ft
  • Final Pass:
 30 - 45 Degrees
Drivetrain and Front Suspension Cradle Front Bolt (1)
  • First Pass:
 100 N.m 74 lb ft
  • Final Pass:
 90 - 105 Degrees
Drivetrain and Front Suspension Cradle Rear Bolt (1)
  • First Pass:
 100 N.m 74 lb ft
  • Final Pass:
 90 - 105 Degrees
Drivetrain and Front Suspension Crossmember Extension Front Bolt 58 N.m 43 lb ft
Transmission Mount Strut Bolt (1)
  • First Pass:
 100 N.m 74 lb ft
  • Final Pass:
 90 - 105 Degrees
Exhaust Muffler Insulator Nut 22 N.m 16 lb ft
Stabilizer Shaft Link Nut (1) 65 N.m 48 lb ft
(1) = Use NEW fastener.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.