Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Chevrolet Camaro SS, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Body Control Module Replacement

Fig 1: Body Control Module

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Body Control Module Bracket Bolt (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Tighten
9 N.m (80 lb in)

Body Control Module

Procedure

Disconnect the electrical connectors.
Swing the body control module bracket forward, release the bracket tab and slide module out of the bracket.
Control Module References for programming and set-up information, if required.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.