2015 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE

Approximate Fluid Capacities

The following approximate capacities are given in US English and metric conversions. See Fluid and Lubricant RecommendationsΒ  for more information.

Application Specification
Metric US English
Cooling System 10.8 liters 11.4 quarts
Engine Oil With Filter 5.7 liters 6.0 quarts
Engine Oil Without Filter 5.2 liters 5.5 quarts
Fuel Tank 83.3 liters 22.0 gallons
Transfer Case 1.0 liters 1.06 quarts
Hydraulic Brake System 0.57 liters 1.2 pints
Transmission Fluid
  • Fluid Change- Drain Plug- Approximate Capacity
4.0-6.0 liters 4.2-6.3 quarts
  • Overhaul- Approximate Capacity
7.0-9.0 liters 7.4-9.5 quarts
  • Valve Body Cover Removal- Approximate Capacity
5.0-7.0 liters 5.3-7.4 quarts
All capacities are approximate. When adding, be sure to fill to the approximate level, as recommended in this manual. Recheck the fluid level after filling.
Refrigerant System Capacities
Total System PAG Oil Capacity 230 ml 7.8 oz
Compressor 75 ml1 2.5 oz1
The Denso service compressor contains 75 ml (2.5 oz) of PAG oil.
Condenser with Desiccant 20 ml1 0.6 oz1
Desiccant Cartridge Only 10 ml1 0.3 oz1
Evaporator, Front 10 ml1 0.3 oz1
Evaporator, Rear 10 ml1 0.3 oz1
Abrupt Refrigerant Loss 60 ml2 2.0 oz2
Refrigerant Charge, R134a 1.125 kg 2.5 Lb
1 If more than the specified amount of PAG oil was drained from a component, add the equal amount of oil drained.
2 Abrupt refrigerant loss due to large leak, hose rupture, collision, or pressure relief valve opening. Conditions that allow the refrigerant to seep or bleed off over time do not cause this oil loss. Upon replacement of a component that caused a large refrigerant loss, also add the required amount of oil for the particular component.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.