2015 Chevrolet Spark LS, Standard TransFACTORY OEM SERVICE PROCEDURE

Throttle Body Assembly Replacement (LFM)

Fig 1: Throttle Body Assembly (LFM)
GM3415984Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  3. Disconnect the throttle body connector.
1 Throttle Body Retaining Bolt (Qty: 4)
CAUTION: Refer to Fastener Caution .

Procedure 
Remove the throttle body retaining bolts.
Tighten 
10 N.m (89 lb in)
2 Throttle Body Assembly
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.