2015 Chevrolet Spark LS, Standard TransFACTORY OEM SERVICE PROCEDURE

Remote Control Door Lock Receiver Replacement

Fig 1: Remote Control Door Lock Receiver
GM3632599Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement .
  2. Remove the radio. Refer to Radio Replacement .
1 Remote Control Door Lock Receiver Nut (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten 
8 N.m (71 lb in)
2 Remote Control Door Lock Receiver

Procedure

  1. Disconnect the electrical connector.
  2. Remove the remote control door lock receiver and bracket assembly.
  3. Remove the remote control door lock receiver from the bracket.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.