Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2015 Chevrolet SS Standard TransFACTORY OEM SERVICE PROCEDURE

Installation Procedure

Fig 1: Front Fuel/Brake Pipe Assembly Protection Plate

Courtesy of GENERAL MOTORS COMPANY

Manoeuvre and install the fuel pipe (4) to the vehicle.

NOTE:

Observe the marked positions for the fuel/brake pipe retainers (2) when installing the fuel/brake pipe retainers (2) to the fuel/brake pipe assembly (5).

Install all the fuel/brake pipe retainers (2) to the fuel/brake pipes assembly (5).
Install the front fuel/brake pipe assembly protection plate (1) to the vehicle.

Fig 2: Identifying Retaining Nuts & Bolts

Courtesy of GENERAL MOTORS COMPANY

Install the rear fuel/brake pipe assembly stone guard to the vehicle.

CAUTION:

Refer to Fastener Caution .

Install the rear fuel/brake pipe assembly stone guard retaining nuts (1) and tighten to 4 N.m (35 lb in).

Fig 3: Identifying Fuel Feed Line & Fuel EVAP Hose

Courtesy of GENERAL MOTORS COMPANY

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.