Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2015 Chevrolet SS Standard TransFACTORY OEM SERVICE PROCEDURE

Removal Procedure

CAUTION:

To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.

Prepare the electronic brake control module (EBCM) for removal. Refer to Control Module References .
Place the ignition switch in the OFF position.

Fig 1: Electronic Brake Control Module

Courtesy of GENERAL MOTORS COMPANY

Thoroughly clean the area around the EBCM of all dirt and debris.
Disconnect the EBCM electrical connector.
Remove the EBCM bolts (1).

Fig 2: EBCM & Brake Pressure Modulator Valve

Courtesy of GENERAL MOTORS COMPANY

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.