2015 Chevrolet SS Automatic TransFACTORY OEM SERVICE PROCEDURE

Front of Instrument Panel Components

Front of Instrument Panel Components

Items
1: S30 Headlamp Switch S30 Headlamp Switch
2: S27 Head-Up Display Switch (UV6) S27 Head-Up Display Switch UV6
3: P16 Instrument Cluster P16 Instrument Cluster
4: P29 Head-Up Display (UV6) P29 Head-Up Display UV6
5: S38 Ignition Mode Switch (BTM) S38 Ignition Mode Switch BTM
6: P19B Speaker - Center Instrument Panel (UQA) P19B Speaker - Center Instrument Panel UQA
7: B10B Ambient Light/Sunload Sensor B10B Ambient Light/Sunload Sensor
8: A20 Radio/HVAC Controls P17 Info Display Module X1P17 Info Display Module X2P17 Info Display Module X3
9: A11 Radio A11 Radio X1A11 Radio X10A11 Radio X4A11 Radio X5A11 Radio X7A11 Radio X8A11 Radio X9
10: F101 Passenger Instrument Panel Air Bag F101 Passenger Instrument Panel Air Bag X1F101 Passenger Instrument Panel Air Bag X2
11: S26 Hazard Warning Switch
12: F114P Knee Air Bag - Passenger F114P Knee Air Bag - Passenger
13: A26 HVAC Controls A26 HVAC Controls
14: E27 Instrument Panel Compartment Lamp (U27) E27 Instrument Panel Compartment Lamp
15: X80F Accessory Power Receptacle - Front X80F Accessory Power Receptacle - Front
16: X84 Data Link Connector X84 Data Link Connector
17: F114D Knee Air Bag - Driver F114D Knee Air Bag - Driver
Fig 1: Front of Instrument Panel Components
GM3600192Courtesy of GENERAL MOTORS COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.