Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Chevrolet Impala Limited LSFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
WARNING: This page is about a different car, the 2015 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Rear Suspension Lower Control Arm Inner Nut (Requires a NEW Bolt) | ||
|
90 N.m | 66 lb ft |
|
60 degrees | |
| Front Steering Linkage Tie Rod Jam Nut | 60 N.m | 44 lb ft |
| Rear Suspension Toe Adjust Link Inner Nut (Requires a NEW Bolt) | ||
|
90 N.m | 66 lb ft |
|
60 degrees | |
| Front Steering Knuckle Nut (at Strut Assembly) (Requires a NEW Bolt) | ||
|
85 N.m | 63 lb ft |
|
60 degrees | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.