SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015CRUZE ECO, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESDATA COMMUNICATION SYSTEMREPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENT
2015 Chevrolet Cruze Eco, Automatic Trans

Body Control Module Replacement

2015 Chevrolet Cruze Eco, Automatic TransSECTION Body Control Module Replacement
Fig 1: Body Control Module
GM2189275Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Prepare body control module for replacement. Refer to Control Module References .
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove instrument panel lower trim panel - right side. Refer to Instrument Panel Lower Trim Panel Replacement - Right Side .
1 Body Control Module Fastener
CAUTION: Refer to Fastener Caution .
2 Body Control Module

Procedure

  1. Disconnect electrical connector.
  2. Unclip body control module from body control module bracket.
  3. After replacement, refer to Control Module References for programming and set up procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.