Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Chevrolet Cruze DieselFACTORY OEM SERVICE PROCEDURE
Circuit/System Verification
- Engine running for 10 s.
- Ignition ON, engine OFF, verify DTC U0400-U05FF is not set.
- If DTC U0400-U05FF is set along with other DTCs set
Diagnose all other DTCs first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If DTC U0400-U05FF is set without other DTCs set
- Program the device specified by the DTC descriptor.
- Verify the DTC does not set.
- If the DTC sets, replace the appropriate device.
- If the DTC does not set
- All OK.
- If DTC U0400-U05FF is not set
- If DTC U0400-U05FF is set along with other DTCs set
- All OK
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.