2015 Chevrolet Cruze DieselFACTORY OEM SERVICE PROCEDURE

Communication Interface Module Replacement

Fig 1: Communication Interface Module
GM2348937Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the communication interface module bracket. Refer to Communication Interface Module Bracket Replacement .
1 Communication Interface Module

Procedure

  1. Disconnect the electrical connections.
  2. If replacing the communication interface module be sure to transfer Bluetooth antenna, if equipped.
  3. For programming and set up procedures, refer to Control Module References .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.