Quick Lookups: Fluids

2015 Chevrolet Captiva Sport LTZSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 5.30 OZS. 0.15 L PAG 46 S
Air Cond Refrigerant 1.37 LBS. 0.62 KG R-134a S
Automatic Transmission Fluid Fluid Change - Drain Plug N/A N/A Automatic Transmission Fluid DEXRON VI Fluid Capacity is between: 4.2 - 6.3 qts. All capacities are approximate. When adding, be sure to fill to the approximate level. Recheck the fluid level after filling. S
Automatic Transmission Fluid Overhaul N/A N/A Automatic Transmission Fluid DEXRON VI Fluid Capacity is between: 8.5 - 9.0 qts. All capacities are approximate. When adding, be sure to fill to the approximate level. Recheck the fluid level after filling. S
Automatic Transmission Fluid Valve Body Cover Removal N/A N/A Automatic Transmission Fluid DEXRON VI Fluid Capacity is between: 5.3 - 7.4 qts. All capacities are approximate. When adding, be sure to fill to the approximate level. Recheck the fluid level after filling. S
Brake Fluid N/A N/A DOT 3 Hydraulic Brake Fluid S
Engine Coolant 9.00 QTS. 8.51 L 50/50 mixture of DEX-COOL and clean, drinkable water S
Engine Oil w/Filter 5.00 QTS. 4.73 L API - SAE 5W-30 Use only engine oil licensed to the dexos1 specification or equivalent, of the proper SAE viscosity grade. ACDelco dexos1 Synthetic Blend is recommended. SAE 5W-30 is the best viscosity grade for the vehicle. Do not use other viscosity grade oils such as SAE 10W-30, 10W-40, or 20W-50. If in an area of extreme cold, where the temperature falls below -20Deg.F (-29Deg.C), an SAE 0W-30 oil may be used. An oil of this viscosity grade will provide easier cold starting for the engine at extremely low temperatures. S
Fuel Tank 21.60 GALS. 81.76 L S
Windshield Washer Fluid N/A N/A Windshield Washer Fluid Follow the Manufacturer's Instructions for the mixture ratio. Use only fluid that meets regional freeze protection requirements. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.