Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Chevrolet VoltFACTORY OEM SERVICE PROCEDURE
Object Detection System And Pedestrian Protection System
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- Diagnostic Code Index
- DTC B0954, B0955, B0956 or B0957: Parking Assist Front Sensor
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC B0958, B0959, B0960 or B0961: Parking Assist Rear Sensor
- DTC B0967 or B0968: Parking Assist On/Off Switch
- DTC B0987: Vehicle Direction Camera Indicator
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC B1011: System Disabled Information Stored
- DTC B1015: Vehicle Identification Number Information Malfunction
- DTC B1405: Control Module Voltage Reference Output 2
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC B356A: Vehicle Direction Warning Switch Circuit Short to Ground
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Test
- Repair Instructions
- DTC B390D: Frontview Camera Module Incorrect Mounting
- Symptoms - Object Detection
- Forward Collision Alert System Malfunction
- Parking Assist System Malfunction
- Rear Vision Camera System Malfunction
- Lane Departure Warning System Malfunction
- Repair Instructions
- Description and Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.