Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2014 Chevrolet Trax LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Accessory AC and DC Power Control Module Replacement

Fig 1: Accessory AC and DC Power Control Module

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Preliminary Procedure
Remove the quarter lower rear trim panel - left side. Refer to Quarter Lower Rear Trim Panel Replacement .

Accessory AC and DC Power Control Module Fasteners (Qty: 3)

CAUTION:

Fastener Caution .

Tighten
9 N.m (80 lb in)

Accessory AC and DC Power Control Module

Procedure

Disconnect the electrical connectors.
For programming and setup procedures, refer to Control Module References .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.