Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2014TRAVERSE LT, 4D UTILITYREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISDATA COMMUNICATION SYSTEMREPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENT

2014 Chevrolet Traverse LT, 4D Utility

Body Control Module Replacement

2014 Chevrolet Traverse LT, 4D UtilitySECTION Body Control Module Replacement

Fig 1: Identifying Body Control Module

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Preliminary Procedure

Remove the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
Remove the driver side knee bolster. Refer to Driver Knee Bolster Replacement (Acadia) , Driver Knee Bolster Replacement (Enclave) , Driver Knee Bolster Replacement (Traverse) .

Body Control Module

Procedure

Disconnect the electrical connectors.
Reprogram the module if replaced. Refer to Control Module References .

TIP: Push tab to release the body control module from the bracket.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.