Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Chevrolet Spark EVFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Position the electronic power steering control module (2) on the electronic power steering control module bracket (3).
- Install the electronic power steering motor control module to bracket bolts (1) and tighten to 3 (27 lb in).
- Position the electronic power steering motor control module and bracket in the vehicle.
- Install the electronic power steering motor control module bracket bolts (1) and tighten to 18 (13 lb ft).
- Connect the electrical connectors.
- Install the driver side instrument panel lower airbag. Refer to Instrument Panel Lower Airbag Replacement - Driver Side .
- Install the instrument panel knee bolster. Refer to Instrument Panel Knee Bolster Replacement .
- Install the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .
- If a NEW electronic power steering motor control module is installed, program the module. Refer to Power Steering Control Module Programming and Setup .
CAUTION:
Refer to Fastener Caution .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.