Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Chevrolet SSFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Steering Gear Bolt (1) | ||
|
50 N.m | 37 lb ft |
|
115-125 Degrees | |
| Steering Linkage Inner Tie Rod | 98 N.m | 72 lb ft |
| Steering Linkage Outer Tie Rod Nut | ||
|
25 N.m | 18 lb ft |
|
120 Degrees | |
| 1. Torque-to-yield fastener in use, requires NEW bolt. | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.