Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Chevrolet SSFACTORY OEM SERVICE PROCEDURE
Mass Airflow Sensor with Intake Air Temperature Sensor Replacement
Mass Airflow Sensor with Intake Air Temperature Sensor Replacement
| Callout | Component Name |
|---|---|
| Procedure Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement . |
|
| 1 | Air Cleaner Outlet Duct Clamp
CAUTION:
Refer to Fastener Caution . Tighten 2 (18 lb in) |
| 2 | Mass Airflow with Air Intake Temperature Sensor
NOTE:
Pay close attention to the direction arrow on the MAF/IAT sensor. The arrow MUST point toward the engine. Procedure
|
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.