Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Chevrolet SSFACTORY OEM SERVICE PROCEDURE
Accelerator Pedal Position Sensor Replacement
Accelerator Pedal Position Sensor Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the instrument panel lower trim panel insulator right side. Refer to Instrument Panel Lower Trim Panel Insulator Replacement - Right Side . |
|
| 1 | Accelerator Pedal Position Sensor Bolt
CAUTION:
Refer to Fastener Caution Tighten 9 N.m(80 lb in) |
| 2 | Accelerator Pedal Position Sensor Procedure Disconnect the electrical connector. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.