Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Chevrolet SSFACTORY OEM SERVICE PROCEDURE
Battery, Charging System And Starting System
- Specifications
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- Diagnostic Code Index
- DTC B1325, B1330, B1420, B1424, B1517, C0800, P0560, P0562, or P0563: Device Power Circuit Voltage
- DTC B1516: Battery Current Sensor
- DTC B151A: Battery Capacity Performance
- DTC B1527: Parasitic Load
- DTC P0615: Starter Relay
- DTC P0621: Generator L-Terminal Circuit
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0622: Generator F-Terminal Circuit
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- Symptoms - Engine Electrical
- Battery Inspection/Test
- Battery Charging
- Battery Electrical Drain/Parasitic Load Test
- Charging System Test
- Generator Noise Diagnosis
- Starter Solenoid Does Not Click
- Starter Solenoid Clicks, Engine Does Not Crank
- Engine Cranks Slowly
- Starter Noise Diagnosis
- Repair Instructions
- Battery Negative Cable Disconnection and Connection
- Battery Current Sensor Replacement
- Battery Negative Cable Replacement
- Battery Positive Cable Replacement
- Battery Positive Cable Extension Cable Replacement
- Engine Wiring and Battery Positive Cable Harness Replacement (LS3)
- Battery Replacement
- Battery Tray Replacement
- Engine Ground Cable Replacement (LS3)
- Starter Replacement (LS3)
- Starter Shield Replacement (LS3)
- Generator Bracket Replacement (LS3)
- Generator Replacement (LS3)
- Description and Operation
- Special Tools and Equipment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.