Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Chevrolet Impala Limited LSFACTORY OEM SERVICE PROCEDURE
Rear Object Alarm Control Module Replacement
WARNING: This page is about a different car, the 2014 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Rear Object Alarm Control Module Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Reposition the rear compartment side trim panel enough to gain access to the module. Refer to Rear Compartment Side Trim Replacement - Left Side (Without HP6) , Rear Compartment Side Trim Replacement - Left Side (With HP6) . |
|
| 1 | Rear Object Alarm Control Module Fastener
CAUTION:
Refer to Fastener Caution . Tighten 4.5 N.m (40 lb in) |
| 2 | Rear Object Alarm Control Module Retainer |
| 3 | Rear Object Alarm Control Module Procedure
|
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.