Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Chevrolet Impala LSFACTORY OEM SERVICE PROCEDURE
Power Steering System
- Specifications
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- Diagnostic Code Index
- DTC C005B: Power Steering Softstops Learn (NJ1)
- DTC C0176: Control Module Temperature Sensor (NJ1)
- DTC C0176: Control Module Temperature Sensor (NJ2)
- DTC C044A: Steering System Engine Speed Signal (NJ1)
- DTC C0456: Steering Position Sensor (NJ1)
- DTC C0475: Electric Steering Motor (NJ1)
- DTC C0475: Electric Steering Motor (NJ2)
- DTC C047A: Electric Steering Motor Position Sensor (NJ1)
- DTC C0544: Steering Wheel Angle Sensor (NJ1)
- DTC C0544: Steering Wheel Angle Sensor (NJ2)
- DTC C0545: Steering Wheel Torque Sensor (NJ1)
- DTC C0545: Steering Wheel Torque Sensor (NJ2)
- DTC C055C: Steering Gear Performanc (NJ1)
- DTC C055C: Steering Gear Performance (NJ2)
- DTC C0565: 5A Vehicle Identification Number Not Plausible (NJ1)
- DTC C0569: 3A System Configuration Incorrect Component Installed (NJ1)
- DTC C0569: Internal Check Sum Error/Calibration Not Programmed (NJ2)
- DTC C0710: Steering Position Signal Invalid Data (NJ1, NJ2)
- Symptoms - Power Steering System
- Rattle, Clunk, Pop or Shudder Noise from the Power Steering System
- Whine or Growl Noise from the Power Steering System
- Increase in Effort While Turning Steering Wheel
- Poor Return of Steering Wheel
- Steering Wheel Surges/Jerks While Turning
- Steering Wheel Kickback
- Steering Effort Hard or Too Easy in One or Both Directions
- Repair Instructions
- Steering Linkage Inner Tie Rod Inspection
- Steering Linkage Outer Tie Rod Inspection
- Steering Linkage Outer Tie Rod Replacement
- Steering Gear Boot Replacement (NJ2)
- Steering Gear Boot Replacement (NJ1)
- Steering Gear Heat Shield Replacement (NJ1)
- Steering Gear Heat Shield Replacement (NJ2)
- Electric Belt Drive Rack and Pinion Steering Gear Replacement (LFX, M7W, NJ2)
- Electric Dual Pinion Rack and Pinion Steering Gear Replacement (LUK, MHH, NJ1)
- Electric Dual Pinion Rack and Pinion Steering Gear Replacement (LKW, MH7, NJ1)
- Steering Linkage Inner Tie Rod Replacement (NJ2)
- Steering Linkage Inner Tie Rod Replacement (NJ1)
- Steering Gear Drive Coupling Replacement (NJ1)
- Power Steering Assist Motor Replacement (NJ1)
- Power Steering Assist Motor Replacement (NJ2)
- Power Steering Control Module Calibration (NJ1)
- Description and Operation
- Special Tools and Equipment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.