Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Chevrolet Express 2500 Base, Van Cargo Extended, 6.0L Eng VIN GFACTORY OEM SERVICE PROCEDURE
Data Communication System
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- Diagnostic Code Index
- Control Module U Code List
- DTC B1000: Electronic Control Unit/Side Object Detection Performance
- DTC B1001: Option Configuration Error
- DTC B1004: Keep Alive Memory
- DTC B1016: VIN Not Programmed
- DTC B101D: ECU Hardware
- DTC B101E: Electronic Control Unit Software
- DTC C0550: Electronic Control Unit
- DTC U0020: Low Speed CAN Communication Bus
- DTC U0073 or U2100: Control Module Communication Bus/Controller Area Network (CAN) Bus/ECU HS-LS Bus
- DTC U0074: Control Module Powertrain Expansion Communication Bus
- DTC U0100 - U02FF: Module Error (except U029D and U029E)
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC U0100 - U02FF: Lost Communication with NOX Sensor Module (U029D and U029E only)
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC U1500, U1511, U1512 or U1513: LIN Bus/Lost Communication With RCM
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC U1814: Powertrain High Speed Communication
- DTC U1826: Lost Communication With Multi-Axis Acceleration Sensor Module
- DTC U1865: Fuel Operated Heater Lost Communication with Engine Control Module
- DTC U2099: High Speed Communication Enable Circuit
- Symptoms - Data Communications
- Scan Tool Does Not Power Up
- Scan Tool Does Not Communicate with High Speed GMLAN Device
- Scan Tool Does Not Communicate with Low Speed GMLAN Device
- Data Link References
- Repair Instructions
- Description and Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
