Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Chevrolet Trax LS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Circuit/System Verification
- Ignition ON.
- Verify that DTC B1325, B1330, B1370, B1380, B1424, B1440, B1441, B1517, C0800, C0899, C12E1, P0560, or P0562 is not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle to diagnose those DTC's first.
- If none of the DTCs are set
- If any of the DTCs are set
- Verify DTC C0550 is not set.
- If DTC C0550 is set symptom byte 39 or 43
- Program the device that set the DTC.
- Verify the DTC does not set.
- If the DTC sets, replace the device that set the DTC.
- If the DTC does not set
- All OK.
- If DTC C0550 is set with any symptom byte, except symptom byte 39 or 43
Replace the device that set the DTC.
- If DTC C0550 is not set
- All OK
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.