2013 Chevrolet Traverse LTZ, FWDFACTORY OEM SERVICE PROCEDURE

Circuit/System Verification

IMPORTANT:

When performing the 10-Minute Vehicle Key Relearn Procedure, all keys not learned at that time will be erased and not be recognized. Perform the Adding Keys procedure on all keys or instruct the customer how to perform the Adding Keys procedure should all keys not be present at the time of repair.

  1. Verify DTC B3055 is not set.
  2. Verify the scan tool TDM Learn Coded Key parameter displays Yes.
  3. Perform the 10 Minute Vehicle Key Relearn procedure. Refer to Replacing Keys (Canada)Β  or Replacing Keys (North America except Canada)Β . The TDM should exit the learn coded key state and DTC B3031 should clear.
    • If the TDM does not exit the learn coded key state after the programming attempt, replace the TDM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.