2013 Chevrolet Traverse LS, AWDFACTORY OEM SERVICE PROCEDURE

Circuit/System Verification

  1. Ignition ON.
  2. Verify that DTC C0710 and U2142 are not set.
    • If only DTC C0710 is set 

      Refer to Circuit/System Testing below - Only DTC C0710 is set

    • If only DTC U2142 is set 

      Refer to Circuit/System Testing below - Only DTC U2142 is set

    • If both DTC C0710 and U2142 are set 

      Refer to Circuit/System Testing below - Both DTC C0710 and U2142 are set

  3. All OK
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.