Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2013 Chevrolet Spark LS, Standard TransFACTORY OEM SERVICE PROCEDURE

Air Cleaner Assembly Replacement

Fig 1: Air Cleaner Assembly

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Open the hood and disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection . Disconnect the air flow sensor connector.
1	Breather Hose Procedure Disconnect the breather hose (1) and clamp from the air cleaner outlet duct.
2	Air Cleaner Assembly Retaining Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . Procedure Remove the air cleaner assembly retaining bolt (3). Tighten 6 (53 lb in)
3	Air Cleaner Assembly Procedure Disconnect the resonator duct from the air cleaner assembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.