2013 Chevrolet Spark LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Relieve the fuel pressure. Refer to Fuel Pressure ReliefΒ .
  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Fig 1: Intake Manifold Rear Bracket Bolts
    GM2810086Courtesy of GENERAL MOTORS COMPANY
  5. Remove the 2 intake manifold rear bracket bolts (up) (1).
  6. Remove the intake manifold rear bracket bolt (down) (3).
  7. Remove the intake manifold bracket (2).
  8. Fig 2: Fuel Rail Retaining Bolts
    GM2810087Courtesy of GENERAL MOTORS COMPANY
  9. Remove the fuel rail retaining bolts (1).
  10. Lower the vehicle.
  11. Fig 3: Fuel Rail And Fuel Injector
    GM2810089Courtesy of GENERAL MOTORS COMPANY
  12. Remove the positive crankcase ventilation hose. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement .
  13. Disconnect the fuel feed line quick connect fitting from the fuel rail. Refer to Metal Collar Quick Connect Fitting ServiceΒ .
  14. Disconnect the fuel rail and fuel injector connector.
  15. Remove the fuel rail and fuel injector (1).
  16. Transfer parts as necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.