2013 Chevrolet Sonic RS, Standard TransFACTORY OEM SERVICE PROCEDURE

Front View Camera Replacement

WARNING: This page is about a different car, the 2014 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front View Camera
GM3419132Courtesy of GENERAL MOTORS COMPANY
Front View Camera Replacement

Callout Component Name
Preliminary Procedure 
Remove the windshield outside moisture sensor cover. Refer to Windshield Outside Moisture Sensor Cover Replacement .
1 Front View Camera

Procedure

  1. Gently depress top center tab on bracket to release camera.
  2. Disconnect the electrical connector.
  3. Program and calibrate the front view camera. For programming and set up, refer to Front View Camera Module Calibration .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.